1/ Please read ALL of the conditions below as they form part of the description. 2/ This kit is NOT supplied with an engineering certificate for'road use. 3/ We also advise you employee professional help with the installation.Or with someone who has knowledge on installing a complex kit. 2x Front Heavy Duty Wishbone/Control. All bolts, nuts and washers required to fit the kit. The wishbones/control arms in this kit may appear to be very similar to your factory.
Wishbones but they are not. When you sit them side by side you will see a.
Ours are far more heavy duty than the factory. Ours are also set at a different angle so that when they are. Installed and the torsion bar is wound back up again, the vehicle is.
Comfortably and easily lifted without creating extra stress on the CV's. This kit was designed as a'do-it-yourself' installation but you will need some mechanical knowledge.
If you're not confident in this area we would suggest you hand it over to someone who is. Please note You will need a front end wheel alignment after installing the kit but this goes for all lift kits as raising the truck height alters the suspension geometry.Failure to do so may result in tyre scrubbing. Please take a photo of your 4X4 showing upper control arm, and send it to us.
This will ensure we send you the correct item. Bank Transfer is possible if required. Kit is sent directly from the supplier in Thailand to you. This kit weighs 13kg and will therefore be posted in 1 box. This Item is Brand New and is described as accurately as possible.
Images shown are for illustration purposes only and actual item may differ slightly in colour. The item "Mitsubishi Pajero//shogun 3 Heavy Duty Control Arm / Wishbone lift kit set" is in sale since Wednesday, August 29, 2018.
This item is in the category "Vehicle Parts & Accessories\Car & Truck Parts\Suspension, Steering\Leaf Springs". The seller is "daryl3412" and is located in Thailand Direct/Bendigo, Victoria. This item can be shipped worldwide.