Set Heavy Duty

Mitsubishi/L200/Triton/ML/MN 3 Heavy Duty Control Arm / Wishbone lift kit set

Mitsubishi/L200/Triton/ML/MN 3 Heavy Duty Control Arm / Wishbone lift kit set

Mitsubishi/L200/Triton/ML/MN 3 Heavy Duty Control Arm / Wishbone lift kit set    Mitsubishi/L200/Triton/ML/MN 3 Heavy Duty Control Arm / Wishbone lift kit set
MITSUBISHI L200/ML/MN 4X4 2.5"- 3" Heavy Duty Arm control/Wishbone. 1/ Please read ALL of the conditions below as they form part of the description.

2/ This kit is NOT supplied with an engineering certificate for'road use. 3/ We also advise you employee professional help with the installation. Or with someone who has knowledge on installing a complex kit. 2x Front Heavy Duty Wishbone/Control Arm. 2x Rear Replacement Shackles with Greasable pins.

2x 1 front struts spacer. All bolts, nuts and washers required to fit the kit. The wishbones/control arms in this kit may appear to be very similar to your factory wishbones but they are not.

When you sit them side by side you will see a noticeable difference. Ours are far more heavy duty than the factory wishbone. Ours are also set at a different angle so that when they are installed and the spring spacers are installed, the vehicle is sitting comfortably and lifted without creating extra stress on the CV's and the other components in the suspension. The rear components are simply longer and again heavier duty shackles with greasable pins.

Remove the factory shackle and replace with ours, simple as that. This kit is all you need to get between a 2.5 - 3 inch lift out of your suspension There is no need to replace springs, struts, shocks or brake lines. This kit was designed as a'do-it-yourself' installation but you will need some mechanical knowledge.

If you're not confident in this area we would suggest you hand it over to someone who is. Please note You will need a front end wheel alignment after installing the kit but this goes for all lift kits as raising the truck height alters the suspension geometry. Failure to do so may result in tyre scrubbing. Bank Transfer is possible if required. This kit weighs 13kg and will therefore be posted in 1 box. This Item is Brand New and is described as accurately as possible. Images shown are for illustration purposes only and actual item may differ slightly in colour. The item "Mitsubishi/L200/Triton/ML/MN 3 Heavy Duty Control Arm / Wishbone lift kit set" is in sale since Tuesday, April 25, 2017. This item is in the category "Vehicle Parts & Accessories\Car & Truck Parts\Suspension, Steering\Leaf Springs". The seller is "daryl3412" and is located in Thailand/Direct/Bendigo, Victoria. This item can be shipped worldwide.

  • Manufacturer Part Number: Does Not Apply
  • Brand: Unbranded/Generic


Mitsubishi/L200/Triton/ML/MN 3 Heavy Duty Control Arm / Wishbone lift kit set    Mitsubishi/L200/Triton/ML/MN 3 Heavy Duty Control Arm / Wishbone lift kit set